Casio E MULTI PJ CAMERA Multifunctional Camera System Uživatelská příručka Strana 67

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 248
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 66
67
SHOOTING A SNAPSHOT
Using Flash Assist
The subject in an image will look too dark if flash intensity is not
enough to reach a subject that is too far away. When this
happens, you can use flash assist to supplement the brightness
of the subject so it appears as if flash illumination was sufficient.
Flash assist is turned on as the initial factory default setting.
Use the following procedure to turn off flash assist when you do
not want to use it.
1. In the REC mode, press [MENU].
2. On the “Quality” tab, select “Flash Assist” and
then press [X].
3. Use [S] and [T] to select “Off” and then press
[SET].
When you want to use flash assist, select “Auto” here.
IMPORTANT!
Flash assist may not produce the desired result for some
types of subjects.
Any of the following can result in the flash assist effect
being canceled out.
Changing the flash intensity (page 66)
Correcting brightness (EV shift) (page 105)
Changing ISO sensitivity (page 110)
Changing the contrast setting (page 114)
Using flash assist can cause an increase in digital noise.
Flash assist not used Flash assist used
Zobrazit stránku 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 247 248

Komentáře k této Příručce

Žádné komentáře