Casio IT-800 Uživatelský manuál

Handheld TerminalUser’s GuideSeriesBe sure to read “Safety Precautions” inside this guide before trying to use your Handheld Terminal. E

E-9Regulatory InformationThe USA and CanadaThe CASIO IT-800 models are designed, tested and found to meet the relevant regulatory standards described

E-10GUIDELINES LAID DOWN BY FCC RULES FOR USE OF THIS UNIT IN THE U.S.A. (not applicable to other areas).NOTICEThis equipment has been tested and fou

E-11L’ utilisation de ce dispositif est autorisée seulement aux conditions suivantes :(1) il ne doit pas produire de brouillage et(2) I’ utilisateur d

E-12DECLARATION OF CONFORMITYWe, the under signed, CASIO Europe GmbH, hereby declare that the following types of the product:Product: Handheld Termina

E-13Checking in the BoxPlease check the contents of the box before using the Handheld Terminal for the fi rst time. Open the box and make sure that al

E-14Handheld Terminal System Confi gurationOptions IT-800 SeriesIT-800 SeriesUSB CradleHA-H60IOCar Mounted-type Battery ChargerHA-H35CHGEthernet Cradle

E-15HA-D21LBAT/HA-D21LBAT-A(Large-capacity Battery Pack) Power Cord for Europe AC-CORD-EU Power Cord for North America AC-CORD-US Power Cord for T

E-16General GuideBackBottom232426272829313233 34302221Left Right25171820Front123 4568910111213141577251625171820251619IT-800RGC-0519IT-800R-05IT-800EC

E-171 Receiver Outputs voice sound.2 Indicator 1 Orange: ChargingGreen: Charging completeRed: Battery pack error or the surrounding temperature is out

E-1818 DC Jack The dedicated optional AC adaptor is connected to this jack.19Barcode ReaderLaser light or LED light is emitted from this window that

E-1ContentsSafety Precautions ...E-3Operating Precautions ...

E-19Loading and Removing the Battery PackYour Handheld Terminal uses two types of battery: a battery pack and a memory backup battery.The battery pack

E-20Loading1. Turn the terminal upside down and loosen the hand belt..1%-(4''2. Slide the left and right lock switches for the battery pack

E-21Removing1. Make sure that the Handheld Terminal is turned off. If the power is on, press the power key to turn it off.2. Turn the terminal upside

E-22Charging the Battery PackBattery pack installed in the terminal can be charged using either cradle, battery charger or AC adaptor (AD-S15050B). Ba

E-23Dual Battery ChargerTaking care that the battery pack is oriented correctly, insert it into the Dual Battery Charger.This causes the Charge Indica

E-24Handling the Hand Belt The hand belt is attached to the terminal. Remove it if it is not necessary. To remove the hand belt 1. As shown in the fi g

E-25Connecting the Stylus StringThe string can be connected to stylus and hand belt to prevent loss of stylus or misplacing. Follow the instruction be

E-26Attaching the Neck StrapThe neck strap can be used to prevent the Handheld Terminal from fall when carrying it around. Since there are two strap h

E-27Confi guring Handheld Terminal SettingsCalibrating Touch Screen AlignmentWhenever the response of the touch screen is poor, or operation being exec

E-28Adjusting Display BrightnessYou can use the following procedures to adjust display brightness to make it easier toread under different lighting co

E-2Handling microSD Cards ...E-37Installing...

E-29Using the Laser Scanner (Laser Models)1. After turning on the power, position the laser scanner close to a bar code and then press the trigger key

E-30Using the C-MOS Imager (Imager Models)1. Turn on the Handheld Terminal, position its C-MOS Imager reader port near the bar code or 2D code, and th

E-31Adjusting the Laser Light Emission WidthThe emission width of the laser light emitted by the Handheld Terminal (model dependant) can be adjusted.

E-324. Tap the [Calibration] button. The display appears as shown at right.5. Press the trigger key to emit laser light, and align the light with the

E-33Handling the NFCThe NFC is a technology of contactless IC card for short range communication that enables writing data to card and reading data fr

E-34Performing CommunicationsIR CommunicationIR communication can be used to transfer data between two Handheld Terminals.When performing IR communica

E-35Bluetooth® CommunicationBluetooth® interface can also be used to transfer data between two Handheld Terminals. With Bluetooth® the two Handheld Te

E-36GSM/W-CDMA CommunicationTo use the GSM/W-CDMA functions, you must receive service from a wireless service provider. Available GSM/W-CDMA functions

E-37Handling microSD CardsThe Handheld Terminal supports microSD card.The employment of microSD card slot is dependent on model. See page 18 for the m

E-38Removing1. Make sure that the power on the terminal has been switched off. If the power is still on, press the power key to switch off.2. Remove t

E-3Safety PrecautionsCongratulations upon your selection of this CASIO product. Be sure to read the following Safety Precautions before trying to use

E-39Handling SIM CardsThe Handheld Terminal supports SIM card.The employment of SIM card slot is dependent on model. See page 18 for the models with S

E-40Removing1. Make sure that the power on the terminal has been switched off. If the power is still on, press the power key to switch off.2. Remove t

E-41Handling SD Memory CardsSD memory card can be installed in the SD memory card slot on the Handheld Terminal.The employment of SD memory card slot

E-42Resetting the Handheld TerminalResetting the terminal is the same as resetting a PC. Performing a reset causes all unsaved RAM data to be lost tha

E-431. Hold down Fn key and CLR key while pushing down the reset switch for about 3 seconds with the tip of a stylus until the message shown below app

E-44Warning Label Warning! Never look directly into the laser light.These products scan using laser light. Never look directly into the laser light o

E-45IT-800 Specifi cations Model: IT-800R-05/RGC-05/R-15/RC-15/RGC-15/R-35/RC-35/RGC-35/EC-05/EC-35CPU: Marvell® PXA320 624MHzMemory: 128MB RAM,

E-46NFC: Frequency Band: 13.56 MHz ± 7 KHz Antenna: Magnetic Loop Antenna Operating Magnetic Field: Magnetic Length Output 1.5A/m or greater B

E-47W-CDMA (IT-800RGC-05/RGC-15/RGC-35): Standard: UMTS/W-CDMA: 3GPP release 99 HSDPA: 3GPP release 5 Communication functions: Voice sound, ci

E-48SIM card: Standard: ISO 7816 IC Card standard General specifi cations: Support for 3 V and 1.8 V SIM cardsCamera (IT-800RGC-05/RC-15/RGC-15/RC-3

E-4 WarningDust and MoistureThough the Handheld Terminal is dust and water splash resistant, its options including the battery pack are not. Keep loos

E-49Using the USB Cradle (HA-H60IO)The optionally available USB Cradle (HA-H60IO) makes it possible to transmit system data and fi le data between the

E-501 USB Client Port This port is used to transmit system data and fi le data (download, upload) by connecting the Cradle to a PC using a USB cable (D

E-51Connecting the USB Cradle Power SupplyUse the optional AC adaptor (AD-S42120C-N5/AD-S42120B) for the power supply of the USB Cradle. Always make s

E-524. Connect the USB cable (DT-380USB) to the USB client port on the back of the USB Cradle, and then connect it to the PC. The USB host port is us

E-53Important!Always make sure to fi rst remove the Handheld Terminal from the USB Cradle when switching the selector switch.Allowing the power contact

E-54Specifi cations1. USBProtocol: USB Ver1.1 StandardTransfer Rate: 12Mbps (max.)2. Charging Charging Method: Constant current/voltageCharge Period:

E-55Using the Ethernet Cradle (HA-H62IO)The optionally available Ethernet Cradle (HA-H62IO) makes it possible to transmit system data and fi le data be

E-561 USB Client Port This port is used to transmit system data and fi le data (download, upload) by connecting the Ethernet Cradle to a PC using a USB

E-57Connecting the Ethernet Cradle Power SupplyUse the optional AC adaptor (AD-S42120C-N5/AD-S42120B) for the power supply of the Ethernet Cradle. Alw

E-584. Before using the cradle ports, remove the caps from the ports. When using a LAN, connect one end of the LAN cable to the LAN port and the oth

E-5 CautionForeign ObjectsTake care to ensure that metals or combustible objects are not inserted into the openings of the Handheld Terminal or its o

E-59Important !Never short out the contacts of the Ethernet Cradle. This can damage the Ethernet Cradle.Allowing the power contacts become wet can ca

E-60Using the Cradle-type Battery Charger (HA-H30CHG)The optionally available Cradle-type Battery Charger (HA-H30CHG) lets you charge the Handheld Ter

E-61Connecting the Cradle-type Battery Charger Power SupplyUse the optional AC adaptor (AD-S15050B) for the power supply of the Cradle-type Battery Ch

E-62Important !Never short out the power contacts of the Cradle-type Battery Charger. This can damage the Cradle-type Battery Charger.Allowing the po

E-63Using the Car Mounted-type Battery Charger (HA-H35CHG)The optionally available Car Mounted-type Battery Charger (HA-H35CHG) can be used to charge

E-64Important!Take care to avoid allowing the power contacts to become connected to each other, which creates a short.Regarding the installation of HA

E-65Using the Dual Battery Charger (HA-D32DCHG)The optionally available dual battery charger (HA-D32DCHG) can be used tosimultaneously charge two batt

E-661 Charge Indicator LampThis lamp indicates the charge status of the battery pack(s).Off: Not chargingRed: ChargingRed Flashing: Battery pack probl

E-67Charging a Battery PackUse the optionally available AC adaptor (AD-S42120C-N5/AD-S42120B) for the power supply of the Dual Battery Charger.1. Plug

E-68Connecting Multiple Dual Battery ChargersYou can connect up to three Dual Battery Chargers. Doing so makes it possible to supply power to all the

E-6Optional Lithium-ion Battery Pack DangerNever use the Handheld Terminal and its option including the battery pack and battery next to open fl ame, n

E-69Specifi cations1. Model: HA-D32DCHG2. Charging:Charging Method: Constant voltage (with current limiter) (when one Handheld Terminal has been mou

E-70Using the AC Adaptor (AD-S15050B)With the option AC adaptor (AD-S15050B) directly connected to the terminal, battery pack installed in the termina

E-71Using Rechargeable Battery PacksHA-D20BAT/HA-D20BAT-A HA-D21LBAT/HA-D21LBAT-AYour Handheld Terminal supports use of two battery pack types, one at

CASIO COMPUTER CO., LTD.6-2, Hon-machi 1-chomeShibuya-ku, Tokyo 151-8543, Japan

E-7Power Supply / AC Adaptor WarningDo not use the Handheld Terminal at a voltage other than the specifi ed voltage. Also, do not connect the Handheld

E-8Operating PrecautionsYour Handheld Terminal and its options are precision. Improper operation or rough handling can cause problems with data storag