Casio fx-CG10, fx-CG20 Uživatelský manuál stáhnout pdf (Strana 605)

100

101

ε-23

Using a Custom Probe

7. Using a Custom Probe

The sensors shown in the CASIO, Vernier, and CMA sensor lists under “4. Selecting a

Sensor” are E-CON4 mode standard sensors. If you want to sample with a sensor not

included in a list, you must configure it as a custom probe.

Registering a Custom Probe

1. On the sensor selection screen, press 4(CUSTOM).

This displays the custom probe list screen.

If there is no registered custom probe, the message “No Custom Probe” appears on the

display.

2. Press 1(NEW).

This displays a custom probe setup screen like the one shown below.

3. Press 1(EDIT).

4. Input up to 18 characters for the custom probe name and then press w.

This will cause the highlighting to move to “Slope”.

5. Move the highlighting to the setting you want to configure and then press 1(EDIT).

Setting items are described below.

Slope ... Input the interpolation formula slope (value that specifies constant

a of ax+b)

Intercept ... Input the interpolation formula

y-intercept (value that specifies constant b of

ax+b)

Unit Name ... Input up to eight characters for the unit name.

Warm-up ... Specify the warm-up time.

Type ... Select the sensor type (“0-5V” or “±10V”). Press 4(0-5V) or 5(±10V).

6. Perform auto calibration and zero adjustment of the custom probe as required.

Press 2(CALIB) to perform auto calibration of the custom probe. See “Performing Auto

Sensor Calibration” (

page

ε-20).

Press 3(ZERO) to perform zero adjustment of the custom probe. See “Performing

Sensor Zero Adjustment” (page

ε-21).

•

1 2 ... 600 601 602 603 604 605 606 607 608 609 610 ... 634 635

Komentáře k této Příručce

Žádné komentáře

Casio fx-CG10, fx-CG20 Uživatelský manuál Strana 605

Komentáře k této Příručce

Související produkty a manuály pro ne Casio fx-CG10, fx-CG20