Casio GRAPH25+ E, GRAPH35+ E, GRAPH75+ E Uživatelský manuál stáhnout pdf (Strana 360)

100

101

2-6

Using the Setup Wizard

k Using Setup Wizard to Configure a Photogate Setup

Connection of a Vernier Photogate requires configuration of setup parameters that are

slightly different from parameters for other types of sensors.

To configure a setup for Photogate alone

1. Perform the first two steps of the procedure under “To configure an EA-200 setup using

Setup Wizard” on page 2-2.

2. On the “Select Sensor” screen, select [VERNIER] - [Photogate] - [Gate].

• This displays a screen where you specify whether Photogate is connected to the CH1 or

SONIC channel.

3. Press 1 to specify CH1 or 2 to specify SONIC.

• This causes a “Gate Status” screen to appear.

• “Open” means the photo path is not blocked, while “Close” means the photo path is

blocked.

• The gate status defines what Photogate status should cause timing to start, and what

status should cause timing to stop.

Open-Open ...... Timing starts when the gate opens, and continues until it closes and

then opens again.

Open-Close ...... Timing starts when the gate opens, and continues until it closes.

Close-Open ...... Timing starts when the gate closes, and continues until it opens.

Close-Close ...... Timing starts when the gate closes, and continues until it opens and

then closes again.

1 2 ... 355 356 357 358 359 360 361 362 363 364 365 ... 485 486

Komentáře k této Příručce

Žádné komentáře

Casio GRAPH25+ E, GRAPH35+ E, GRAPH75+ E Uživatelský manuál Strana 360

Komentáře k této Příručce

Související produkty a manuály pro ne Casio GRAPH25+ E, GRAPH35+ E, GRAPH75+ E