Casio GRAPH 25+ Pro, GRAPH 35+, GRAPH 75, GRAPH 85, GRAPH 85SD, GRAPH 95 Uživatelský manuál stáhnout pdf (Strana 346)

100

101

20051101

2-6

Using the Setup Wizard

k Using Setup Wizard to Configure a PhotoGate Setup

Connection of a Vernier PhotoGate requires configuration of setup parameters that are

slightly different from parameters for other types of sensors.

To configure a setup for PhotoGate alone

1. Perform the first two steps of the procedure under “To configure an EA-200 setup using

Setup Wizard” on page 2-2.

2. On the “Select Sensor” screen, select [VERNIER] - [Photogate] - [Gate].

• This displays a screen where you specify whether PhotoGate is connected to the CH1

or SONIC channel.

3. Press 1 to specify CH1 or 2 to specify SONIC.

• This causes a “Gate Status” screen to appear.

• “Open” means the photo path is not blocked, while “Close” means the photo path is

blocked.

• The gate status defines what PhotoGate status should cause timing to start, and what

status should cause timing to stop.

Open-Open ...... Timing starts when the gate opens, and continues until it closes and

then opens again.

Open-Close ...... Timing starts when the gate opens, and continues until it closes.

Close-Open ...... Timing starts when the gate closes, and continues until it opens.

Close-Close ...... Timing starts when the gate closes, and continues until it opens and

then closes again.

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 412 413

Komentáře k této Příručce

Žádné komentáře

Casio GRAPH 25+ Pro, GRAPH 35+, GRAPH 75, GRAPH 85, GRAPH 85SD, GRAPH 95 Uživatelský manuál Strana 346

Komentáře k této Příručce

Související produkty a manuály pro Vodní pumpy Casio GRAPH 25+ Pro, GRAPH 35+, GRAPH 75, GRAPH 85, GRAPH 85SD, GRAPH 95