Casio fx-CG500 Uživatelský manuál Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 83
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
Using the E-CON3 Application
The E-CON3 application makes it possible for you to control a Data Logger from a connected
calculator. It allows you to perform the following operations from the calculator unit.
• Configuring Data Logger sampling parameters
• Starting and ending a Data Logger sampling operation
• Saving sample data
• Analysis and graphing of sample data
Important!
All explanations in this section assume that you are fully familiar with all
calculator and Data Logger (CMA CLAB* or CASIO EA-200) precautions,
terminology, and operational procedures.
The E-CON3 application is designed to get the most out of the
measurement functions of the CASIO EA-200 Data Logger. Though it can
run on a CMA CLAB Data Logger, CLAB does not have a SONIC port,
microphone, or speaker as is equipped on the EA-200. While a calculator
is connected to a CLAB Data Logger, attempting to configure E-CON3
application settings and perform measurement using parameters that are
not supported by CLAB will cause an error.
* For information about CMA and the CLAB Data Logger, visit
http://cma-science.nl/.
Zobrazit stránku 1
1 2 3 4 5 6 7 ... 82 83

Komentáře k této Příručce

Žádné komentáře