Casio fx-CG500 Uživatelský manuál stáhnout pdf (Strana 21)

3-2

Setup

Configuring Advanced Sampling Parameters

This section explains how to configure advanced sampling parameters on the [Sample] and

[Trigger] tabs of the Setup dialog box.

To configure advanced parameters for a single sensor

(1) Perform steps (1) through (6) under “To configure parameters for sampling with a single

sensor” on page 2-1.

(2) On the menu bar, tap [Setup].

• This displays the [Sample] tab of the Setup dialog box.

• The initial [Mode] setting is the mode that matches the sensor that was selected on the

[Single] tab.

(3) Use the [Mode] box to select the mode you want.

• For more information about modes, see “Modes” on page 3-3.

• Selecting a mode causes the applicable parameters to appear on the [Sample] and

[Trigger] tabs.

(4) Use the [Sample] and [Trigger] tabs of the Setup dialog box to configure the required

parameters.

• For details about the required parameters in each mode, see “Mode Parameters” on

page 3-5.

(5) After everything is the way you want, tap [Set].

• This applies your settings and closes the Setup dialog box.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 82 83

Žádné komentáře

Casio fx-CG500 Uživatelský manuál Strana 21